Friday, February 24, 2017

Scrub plane II





Here it is another scrub plane just terminated: beech body and wild olive sole (unfortunately this wood is ending......I'll have to ask again Michele (who lives in Puglia) for supplying me with another little amount of it. 

This time I tried to add a beading moulding to plane sides and I have to say I am satisfied. I cut them with a Stanley 50, equipped with its narrower beading cutter.


The front handle is inserted by a sliding dovetail joint, coupled with a round tenon in its bottom
A mortice and tenon joint has been used for fixing the rear handle, behind the blade. In both cases I used drawbored dowels for reinforcing the joint.
  


The building tecnique is based on cutting and gluing the plane body, so is easier to obtain the throat and cut into the sides for accomodating the wedge and blade.  
 






 






You can see a little hole on the front. Our woodworm friend (died!) loves wild olive, providing to the plane a vintage look. 



4 comments:

  1. It is a nice feeling using a tool you have made.

    ReplyDelete
  2. Good Morning, did you create the blade?

    ReplyDelete
    Replies
    1. Hi, the blade was a new old stock one but with a straight cutting edege, so I had to round it.
      Regards
      Giuliano

      Delete

Note: Only a member of this blog may post a comment.